A built-in stop prevents doors from opening too far—good when wall- or floor-stops can’t be used. Designed for frequently used doors, these closers last twice as long as standard door closers. They can replace Yale, Dorma, Falcon, Stanley, Parker, and Cal-Royal models with the same mounting hole pattern. These closers are reversible for right or left door-swing directions. All meet ANSI A156.4 Grade 1 durability, strength, and performance standards for door controls. Closers that meet UL 10C for fire-rated doors meet positive pressure fire test standards.

Free-moving closers pull doors shut after you've opened them.

Hold-open closers hold doors open until you close them with a slight push or pull on the door.

Nudge your door and these openers will open it the rest of the way. You can also pair them with automatic door switches and buttons. Their delayed closing action holds the door open for a set amount of time before closing. These openers are for doors that weigh up to 200 lbs. and must be hardwired. They are reversible for right or left door-swing directions.

Combine track, mounting brackets, and hangers that fit the same inside track width to create a system for hanging doors. Some components that fit together are rated for different capacities; the capacity of your system is determined by the component with the lowest capacity.

Hangers with bolts attach through the top of your door. They adjust vertically within the bolt's thread length. Two per door are required. Hangers with mounting plate attach around the sides and top of your door. They adjust vertically between the bottom of the track and the top of the door. Two per door are required.

For technical drawings and 3-D models, click on a part number.

For use on spray booths and drying ovens, these latches automatically open when the internal pressure of the enclosure reaches a set level. They can also be manually opened by pulling on the handle. Mount latches horizontally to the face of the door with the strike plate mounted on the frame. To determine door mounting location, look at the outside face of the door: if the hinges are on the right, order a right-side latch; if the hinges are on the left, order a left-side latch.

Door offset is the space between the door face and the frame when the door is closed. Pressure release force is the amount of pressure an enclosed area can sustain before the latch opens. Adjust the catch to make the latch more or less sensitive to pressure. Styles 1 and 2 adjust with a slotted screwdriver.

For technical drawings and 3-D models, click on a part number.

An emergency release handle offers a means of escape if a door closes with someone inside an enclosure. Mount these padlockable latches horizontally to the face of doors on refrigerators, ovens, and industrial enclosures with the strike plate mounted on the frame.

Latches have an adjustable strike plate to compensate for changes in offset caused by sagging doors and worn or flattened gaskets. Door offset is the space between the door face and the frame when the door is closed.

For technical drawings and 3-D models, click on a part number.

Pull the chain-grip to unlatch hard-to-reach doors and panels. Bolts are spring-loaded to stay latched until you activate the pull. All latches have bolts that can be rotated 180°, so they can be used with both push and pull doors. They are reversible for right- and left-hand mounting.

For technical drawings and 3-D models, click on a part number.

A large handle makes gripping these latches easier than other lift-and-drop barrel padlockable slide-bolt latches. Slide the bolt and drop the handle to secure. The handle stays out of the way when not in use. All latches are reversible for right- and left-hand mounting.

For technical drawings and 3-D models, click on a part number.

In addition to being padlockable, this heavy duty latch comes with two handles for access from the inside as well as the outside. It's often used on refrigerators and truck doors. It is reversible for right- and left-hand mounting.

For technical drawings and 3-D models, click on a part number.