McMaster-Carr logo
    Filter by
    System of Measurement
    For Double Flare Angle
    For Tube OD for Double Flare
    Fitting Connection
    Length
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    DFARS Specialty Metals
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    2 Products

    Vise-Mount Tube Flarers for 37° and 45° Flares

    Image of Product. Front orientation. Tube Flarers. Vise-Mount Tube Flarers for 37° and 45° Flares.
    Mount these flarers in a vise and create single and double 37° and 45° flares. Use 37° flares in high-pressure applications and 45° flares in low-pressure applications. Double flares roll the end of tubing in on itself then flare both layers for applications such as brake lines. Type M hard copper should be annealed before flaring.
    For Tube OD
    For Tube OD for Double Flare
    Lg.
    Material
    Each
    For Aluminum, Brass, Copper, Stainless Steel, Steel
    3/16", 1/4", 5/16", 3/8", 4.75 mm4.75 mm, 3/16", 1/4", 5/16", 3/8"11"Steel000000000000000
     

    Hand-Held Tube Flarers for Single and Double 45° Flares

    Image of System. Front orientation. ZoomedIn view. Contains Annotated, Border. Tube Flarers. Hand-Held Tube Flarers for Single and Double 45° Flares.
    Image of Product. Front orientation. Tube Flarers. Hand-Held Tube Flarers for Single and Double 45° Flares.
    Create single or double flares in soft metal tubing so it’s compatible with flared tube fittings. Double flares roll the end of tubing in on itself then flare both layers for applications such as brake lines. A 45° flare is preferred for low-pressure applications. This tool consists of a flaring head and a tube holder.
    For Tube OD
    For Tube OD for Double Flare
    Lg.
    Each
    For Aluminum, Brass, Copper
    3/16", 1/4", 5/16", 3/8", 1/2"3/16", 1/4", 5/16", 3/8", 1/2"7 1/2"0000000000000
     
    back to top