Thickened with silica, this heavy grease clings to parts so it won't wash off in wet environments.

This grease meets NSF/ANSI Standard 51 and FDA 21 CFR 175.300 for direct contact with food and NSF/ANSI Standard 61 for use with components that come into contact with drinking water.

Lubricate the ball and roller bearings that support your highest loads, such as wheels and heavy equipment.

Formulated to resist most chemicals and solvents, this grease keeps bearings lubricated in harsh environments.

Use this grease in food-processing and preparation areas. It is NSF registered H1 or meets FDA Compliant 21 CFR 178.3570 for incidental contact with food.

Use this general purpose grease to lubricate most machinery.

For use in food-processing and preparation areas, this grease is rated for incidental contact with food.

Made with moisture-resistant aluminum thickener, this grease resists washing off and reduces corrosion in wet environments while still lubricating under heavy loads. It is NSF registered H1 for incidental food contact.

Also known as thread lubricants, these general purpose antiseize lubricants prevent threaded fasteners and close-fitting parts from locking together due to corrosion, contamination, or heat.

Often used with engine bolts and heavily-loaded, slow-moving gears, these lubricants are formulated with moly (molybdenum disulfide) to prevent parts from locking together under high loads and pressure.

These lubricants dry to form a thin, solvent-resistant film that won't squeeze out or attract dirt. Use them to prevent threaded fasteners and close-fitting parts from locking together.

Also known as antifriction coatings, these slippery coatings cure to provide permanent lubrication. They're made with moly for high-load applications, such as hinges, gears, and rods. They fill in surface imperfections for a smooth, dry finish that won’t attract dust.

For use in food-processing and preparation areas, these lubricants are rated for incidental food contact. Coat tight-fitting parts with them before sliding together to make assembly easier.

Increase the pressure mineral oil can withstand in low-speed, high-pressure applications, such as gears, plain bearings, and ways.

Thin enough to penetrate inside chain pins and links, yet tacky so it stays in place, use this oil to lubricate chain and roller chain.

For use in food-processing and preparation areas, this oil is NSF registered H1 for incidental food contact.

Also known as paintable mold-release lubricants, these lubricants don’t leave a residue, so you can paint or finish the molded part without the need to clean it. Use them for molding and casting parts in food-processing and preparation areas, or when molding parts that will be used around food. They allow you to easily remove cast parts and prevent sticking, stretching, and tearing.

By traveling along individual strands and penetrating to the core of wire rope and cable, these lubricants maximize coverage to prevent rust and reduce wear. They cut through dirt, grease, and rust to protect wire rope and cable.