Clear All
    System of Measurement
    System of Measurement
    Inch
    Metric
    Head Type
    Head Type
    Show
    Tapped
    Shaft Type
    Shaft Type
    PlainTapered
    D-ProfileSpiral
    Material
    Material
    Steel
    Stainless Steel
    End Shape
    End Shape
    ChamferedRounded
    Pin Type
    Pin Type
    Dowel
    Taper
    Made to Order
    Minimum Hardness
    Minimum Hardness
    Rockwell C18
    Rockwell C47
    Rockwell C52
    Not Rated
    Specifications Met
    Specifications Met
    DIN 7979C-m6
    Tolerance Rating
    Tolerance Rating
    Standard
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    click to learn more about
    Thread Pitch
    Thread Pitch
    click to learn more about
    Passivation
    Passivation
    Passivated
    Not Passivated
    Large End Diameter
    Large End Diameter
    default
    0.289"
    0.341"
    0.409"
    0.492"
    0.591"
    0.706"
    Thread Length
    Thread Length
    1/4"
    3/8"
    7/16"
    1/2"
    5/8"
    3/4"
    7/8"
    Pin Number
    Pin Number
    5
    6
    7
    8
    9
    10
    Rate of Taper
    Rate of Taper
    1/4" per 12"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    415 Products