Slip these pins in and out during maintenance or prototyping—they’re undersized to make alignment easier.

Cut this 12" stock to the length you need.

The flat side of these pins relieves trapped air, making them easier to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

Center-groove pins are often used in place of clevis pins or to create T-handles. The grooved center locks pins in position, while the smooth ends act as a pivot. Also known as type E pins.

These pins make good hinges or pivots. The grooved half locks pins in position, while the smooth half can act as a pivot. Also known as type H pins.

These pins are commonly used as anchors for tension springs. The grooved half locks pins in position, and spring ends fit in to the notch. Also known as type G pins.

Use these as pivot or hinge pins. The knurled half locks pins in position, while the smooth half acts as a pivot.

Center-knurled pins are often used in place of clevis pins or to create T-handles. The knurled center locks pins in position, while the smooth ends act as a pivot.

Use these pins to fasten components made of soft materials such as plastic or aluminum. Opposing barbs bite into each piece, pulling them together for a tight, secure fit.

For use with Browning shear hubs, these pins are designed to fail at specific loads to protect heavy duty machinery from torque overload.

A 60° beveled head fits into a countersunk hole.

A thick shoulder makes these pins more rigid than standard ejector pins.

Also known as roll, tension, split, and expansion pins, these pins have a slot along one side that you squeeze closed to install them into unthreaded holes.

These spiral pins remain flexible after installation, so they absorb shock and vibration better than slotted spring pins. They work well in holes that are out of round.

To remove these pins, hit the small end with a punch to drive the pin out.

These internally threaded pins sit flush in an assembly. For easy removal from a blind hole, thread a screw into the pin and pull out.

Create a custom headed pin with your choice of material, dimensions, and end type.

Weld these pins directly to a surface —no mounting hole required.

Slotted spring pins are also known as roll, tension, split, and expansion pins. Because the slot is pressed closed when the pins are inserted, they don't flex after installation.

Maintain consistent alignment in mating parts by installing a pin in one part and a liner in the other.

Screw the shank into a threaded hole for quick installation and removal.

Encase these pins while molding plastic or composite parts. Once set, the knurls resist movement, letting you align the workpiece with precision on a plate or table.

When locating a workpiece using through-hole alignment pins, use one of these bushings and one standard bushing to prevent the pins from binding in your fixture.

Support and position workpieces and fixtures from the bottom or side. These buttons press into a drilled hole for permanent installation.

Use these buttons to support and position workpieces and fixtures from the bottom or side. Their hex shape lets you screw them into a threaded hole with a wrench or socket.

The swiveling tip supports uneven and angled surfaces.

To align two parts with more precision than standard spring plungers, these index plungers have a mating bushing that improves alignment and repeatability.