Filter by
Thread Size
Thread Spacing
DFARS Compliance
Thread Type
Thread Fit
About Threaded Studs and Rods
More
Tapped Taper Pins
These internally threaded pins sit flush in an assembly. For easy removal from a blind hole, thread a screw into the pin and pull out. Often used for positioning components and securing assemblies, they taper at a uniform rate to fit in tapered holes. Use a tapered drill bit that matches the pin number for a snug fit. They have slightly rounded edges to aid insertion.
Pins meet ASME B18.8.2 specifications for material and dimensions.
For technical drawings and 3-D models, click on a part number.
Partially Threaded Studs
Use the unthreaded end as a pivot point, hinge, shaft, or locator pin. Made from 18-8 stainless steel, these studs are chemical resistant and may be mildly magnetic.
For technical drawings and 3-D models, click on a part number.
Shaft | ||||||||
|---|---|---|---|---|---|---|---|---|
| Lg. | Thread Lg. | Lg. | Dia. | Dia. Tolerance | Tensile Strength, psi  | Hardness | Each | |
18-8 Stainless Steel | ||||||||
10-24 | ||||||||
| 1" | 1/2" | 1/2" | 0.19" | -0.005" to 0.005" | 70,000 | Not Rated | 000000000 | 00000 |
| 1 1/2" | 3/4" | 3/4" | 0.19" | -0.005" to 0.005" | 70,000 | Not Rated | 000000000 | 0000 |
| 2" | 3/4" | 1 1/4" | 0.19" | -0.005" to 0.005" | 70,000 | Not Rated | 000000000 | 0000 |
| 2 1/2" | 3/4" | 1 3/4" | 0.19" | -0.005" to 0.005" | 70,000 | Not Rated | 000000000 | 0000 |
| 3" | 3/4" | 2 1/4" | 0.19" | -0.005" to 0.005" | 70,000 | Not Rated | 000000000 | 0000 |
| 3 1/2" | 3/4" | 2 3/4" | 0.19" | -0.005" to 0.005" | 70,000 | Not Rated | 000000000 | 0000 |
| 4" | 3/4" | 3 1/4" | 0.19" | -0.005" to 0.005" | 70,000 | Not Rated | 000000000 | 0000 |