Twist the wing nut on these plugs to expand the seal.

Tighten the nut on these plugs to expand the seal.

Turn the square head of the plug into the sealing ring to close off pipe openings.

Also known as pneumatic plugs, these plugs conform to wide and out-of-round pipes.

These extra-long plugs allow you to seal off two pipes at the same time. They have two separate inflation chambers to release back pressure gradually and prevent splash back as water clears the drain line.

Insert these plugs deep within your pipe to seal it off from the inside.

Tighten these threaded fittings with your hands for a secure connection in testing, flushing, venting, and plugging applications—no tools, tape, or sealant required.

Use these fittings for low-pressure applications in noncorrosive environments.

These Schedule 40 fittings are the industry standard for gravity-flow drain, waste, and vent (DWV) applications.

With thinner walls than Schedule 40 fittings, these are lighter in weight and have more space on the inside for high-flow applications, such as underground gravity-flow sewer and storm drainage lines. They are also known as SDR 35 fittings.

Often used to prevent spills from going down your drain, these plugs resist oil and most chemicals. They are nonabsorbent, washable, and reusable.

Put an end to water damage from backed-up sewers. When water backs up, the rubber float will rise to seal off the drain. When water recedes, the float will drop for normal drainage.

Close off your drain cleanout pipe with these plugs.

Place a plug into an opening and tighten the wing nut—the sides expand to create a seal in holes of varying diameters.

Mount these drains at the bottom of your enclosure to let moisture drip out and keep electronics dry.

Stop oil, chemicals, and other spills from going down the drain with these magnetic covers.