McMaster-Carr logo
    Filter by
    Number of Drill Bits
    For Drill Bit System of Measurement
    Overall Length
    DFARS Specialty Metals
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    Overall Width
    Overall Height
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    4 Products

    Reduced-Shank Drill Bit Stands

    Each hole is sized to hold the 1/2" shank of a reduced-shank drill bit and marked with a bit size.
    For Drill Bits
    Image of Product. Front orientation. Tap and Drill Bit Stands. Reduced-Shank Drill Bit Stands.
    For
    Drill Bit
    Overall
    Material
    No.
    of
    Size
    Lg.
    Wd.
    Ht.
    Each
    For Inch Drill Bits
     
    1/2" Drill Bit Shank Size
    Steel331/2" to 1" (Increments of 1/64")13"5"2 3/4"2793A27000000
     

    Tap and Drill Bit Stands

    For Drill Bits
    Image of Product. Front orientation. Tap and Drill Bit Stands. For Drill Bits.
    These stands hold one of each bit size. Each hole is marked with the size.
    For
    Drill Bit
    Overall
    Material
    No.
    of
    Size
    Lg.
    Wd.
    Ht.
    Each
    For Inch Drill Bits
     
    For Jobbers' Length, Short Length, Extended Length
    Steel291/16" to 1/2" (Increments of 1/64")5 5/8"2 5/8"1 1/2"2793A12000000
    Steel331/2" to 1" (Increments of 1/64")13"5"2 3/4"2793A2400000
     
    For Letter Size Drill Bits
     
    For Jobbers' Length, Short Length, Extended Length
    Steel26A to Z5 5/8"2 5/8"1 1/2"2793A1800000
     
    back to top