These bits have a round or hex shank that fits into the three-jaw chuck on a hammer drill.

These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

Drill holes up to 1 1/2" in diameter.

Also known as A-taper bits, these fit rotary hammers with a taper-shank chuck.

A more controlled chip removal reduces heat buildup. Use these bits on brittle material such as block and brick.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

Use these bits with handheld power drills, drill presses, and hammer drills.

Insert these bits directly into power screwdrivers, impact drivers, and other tools that accept 1/4" hex shanks.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

A more controlled chip removal reduces heat buildup. Use these bits on brittle materials such as block and brick.