Tough and wear resistant, cobalt steel bits last at least twice as long as high-speed steel. They can also run up to 25% faster at higher temperatures without being damaged on hard materials, such as nickel.

The rigidity of short-length bits without sacrificing reach. The shallow drilling depth makes these less likely to wobble than other bits of the same length, so they stay centered and drill straighter. High-speed steel is good for general purpose drilling in most metals.

With flutes that lift chips out of the hole, you don't have to stop drilling to clear these bits manually. They improve coolant flow to dissipate heat and prevent clogs that can damage the bit and ruin the hole. High-speed steel is good for general purpose drilling in most metals.

Performance similar to solid carbide but at a lower price point. Like carbide bits, these are stronger than cobalt and high-speed steel and maintain their sharp edges when drilling abrasive material. However, when drilling tough metals like iron and hardened steel, upgrade to carbide for longer life.

These bits combine the toughness and wear resistance of cobalt with short flutes for rigidity. The shallow drilling depth makes them less likely to wobble than other bits of the same length, so they stay centered and drill straighter. Cobalt lasts at least twice as long as high-speed steel. It can also run up to 25% faster at higher temperatures without damaging the bit on hard materials such as nickel.

The hardest and most wear-resistant bits with the longest life. Straight flutes withstand the heavy pressure needed to penetrate hardened steel. These bits cut more aggressively and resist stress better than spiral-flute bits. Carbide stays sharp at high temperatures and faster speeds for the best performance on hard and difficult-to-machine materials. It can be brittle, however, so these bits require a rigid machine tool holder to prevent breakage and should not be used in hand drilling applications.

Avoid clogs and dissipate heat with cobalt bits that last at least twice as long as high-speed steel. The flutes clear chips to improve coolant flow and prevent damage to the bit and the hole. They also speed up drilling since you don't have to stop to clear the bit manually.

With more cutting edges than other drill bits, these cut continuously and consistently for a smoother finish. They also stay centered to produce holes that are straighter and more accurate. However, since there’s less space between the cutting edges, they don’t clear chips as quickly. Made of carbide, these are the hardest and most wear-resistant drill bits you can buy. They stay sharp at high temperatures and faster speeds for the best performance on hard and difficult-to-machine materials. Carbide can be brittle, however, so these bits require a rigid machine tool holder to prevent breakage and should not be used in hand drilling applications.

Cut clean holes in abrasive material without fraying or delaminating the surface. Made of carbide, these bits resist wear to retain a sharp edge, even after after hundreds of cuts.

With flutes that spiral in the opposite direction of other bits, these are primarily used to remove stripped screws. Choose a bit that’s slightly smaller than the diameter of the screw’s head. Set your power tool to rotate in reverse. Slowly drill in the center of the screw head, maintaining constant pressure. As the bit penetrates, it will catch onto the screw and reverse it out of the hole. If the screw is badly stripped, you might need to punch a starter hole. Also known as reverse-flute bits. High-speed steel is the versatile choice for drilling most metals.

Harder and more wear resistant than cobalt steel, these carbide bits create an accurate starting place in your workpiece. Cut an indent, then continue drilling with a longer bit. The indent prevents slipping so the final hole is centered and precise. Carbide stays sharp at high temperatures and faster speeds. It can be brittle, however, so these bits require a rigid machine tool holder to prevent breakage and should not be used in hand drilling applications.

Our strongest short-flute bits, these have a carbide tip that stays sharp when drilling abrasive materials, such as titanium. The shallow drilling depth makes them less likely to wobble than other bits of the same length, so they stay centered and drill straighter.