Access hard-to-reach spots and drill deep holes.

More wear resistant than cobalt steel and high-speed steel, carbide-tipped bits maintain a sharper, harder edge at high temperatures for excellent performance on abrasive material, such as plastic. Because they aren’t as brittle as solid carbide bits, they can be used in less rigid setups, such as a hand-held drill.

With better heat and wear resistance than high-speed steel, cobalt steel bits can run up to 25% faster and have a longer tool life.

With better heat and wear resistance than high-speed steel, cobalt steel bits can run up to 25% faster and have a longer tool life.

These bits have a round or hex shank that fits into the three-jaw chuck on a hammer drill.

Drill holes up to 1 1/2" in diameter.

A more controlled chip removal reduces heat buildup. Use these bits on brittle material such as block and brick.

Use these diamond-coated hollow bits for wet drilling of masonry, concrete, and rebar with a drilling rig.

Use these bits with handheld power drills and hammer drills set to rotary-only mode.

Multiple outlining teeth bore clean, flat-bottom holes without chipping or splintering your surface—even when cutting across the grain. Also known as multispur bits.

Also known as spade bits, these have a centering point and two cutting edges for boring holes in hard and soft wood.

The screw point draws the bit in, quickly boring holes without applying pressure.

These hollow bits are diamond-tipped for long life and fast cutting speeds. Only for use in drill presses.

With better heat and wear resistance than high-speed steel, cobalt steel bits can run up to 25% faster and have a longer tool life.