Also known as screw-machine and stub-length bits, these provide maximum rigidity for drilling straighter holes than jobbers'- and maintenance-length drill bits.

The short flutes provide increased rigidity for drilling straighter holes than standard extended-length drill bits.

These jobbers'-length bits have the rigidity and length required for most applications.

Also known as screw-machine and stub-length bits, these provide maximum rigidity for drilling straighter holes than jobbers'-length drill bits.

The short flutes provide increased rigidity for drilling straighter holes than standard extended-length drill bits.

These jobbers'-length bits have the rigidity and length required for most applications.

Three cutting edges instead of the typical two enable these bits to drill holes with a smoother finish than other bits.

Specially-designed flutes keep these bits centered as they drill, resulting in straighter, rounder holes with tighter tolerances. Also known as double-margin drill bits.

The short flutes provide increased rigidity for drilling straighter holes than standard extended-length drill bits.

Also known as screw-machine and stub-length bits, these provide maximum rigidity for drilling straighter holes than jobbers'-length drill bits.

All have a 1/4"-28 threaded shank which installs directly into the threaded spindle on a compatible drill.

These bits have a round or hex shank that fits into the three-jaw chuck on a hammer drill.

A more controlled chip removal reduces heat buildup. Use these bits on brittle material such as block and brick.

Use these bits with handheld power drills, drill presses, and hammer drills.

Insert these bits directly into power screwdrivers, impact drivers, and other tools that accept 1/4" hex shanks.

These bits are cut to match a wood screw’s thread and diameter, resulting in a perfect fit for a screw. They produce clean edges when cutting soft and hard wood.

The sharp point allows for gradual penetration to reduce friction and eliminate cracking and chipping when drilling in plastic.

These hollow bits are diamond-tipped for long life and fast cutting speeds. Only for use in drill presses.

Harder, stronger, and more wear resistant than cobalt steel, solid-carbide bits maintain their sharp edges longer. They require rigid toolholding to prevent breakage and should not be used in hand-held drilling applications.

When one end becomes worn, reverse the bit to use the other end.

Harder, stronger, and more wear resistant than high-speed steel, solid-carbide bits maintain their sharp edges longer. They require rigid toolholding to prevent breakage and should not be used in hand-held drilling applications.

With better heat and wear resistance than high-speed steel, cobalt steel bits can run up to 25% faster and have a longer tool life.

With better heat and wear resistance than high-speed steel, cobalt steel bits can run up to 25% faster and have a longer tool life.

Protect your stainless steel screws by using a stainless steel bit. If steel flakes off a standard bit and into the recess, it can lead to rust and contamination. These bits eliminate that risk.

Strong and durable, these multipurpose bits are for use with bit screwdrivers.

When you don't have exact alignment between the fastener and the tool, the ball end allows angled entry to turn screws in hard-to-reach areas.

When you don't have exact alignment between the fastener and the bit, the ball end allows angled entry to turn screws in hard-to-reach areas. A retaining ring grips inside the recess to hold screws in place.

An opening at the tip accommodates the pin in the recess of tamper-resistant hex screws. These are also known as pin-in-hex or pin-in-socket bits.

The knurled shank on these bits allows finger tightening. They can also be used with the included screwdriver.

An opening at the tip accommodates the pin in the recess of tamper-resistant hex screws. These are also known as pin-in-hex or pin-in-socket bits.

An insulated handle and shaft protect against shock from accidental contact with live electrical circuits. These tools are tested to 1,000 volts to meet EN 60900 and IEC 60900.