Power Source Power Source | Show |
|---|
|
Power Source Power Source | Hide |
|---|
|
|
Pulling Direction Pulling Direction |
|---|
|
Application Application |
|---|
|
Handle Attachment Type Handle Attachment Type |
|---|
|
For Rope Diameter For Rope Diameter |
|---|
|
For Use With For Use With |
|---|
|
Capacity Capacity |
|---|
|
Fully Wound Capacity Fully Wound Capacity |
|---|
|
Brake Type Brake Type |
|---|
|
Body Type Body Type |
|---|
|
Material Material |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
Rope with Hook Included Rope with Hook Included |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
Drill-Wind Precise-Positioning Heavy Duty Hand Winches for Wire Rope—For Lifting
Remove the handle to wind this winch with a power drill and move loads more gradually than with other winches. Its one-piece machined gears stand up to daily use. An automatic brake holds the load when the handle is released. To lift, mount winch above the load or use winch with a pulley that's mounted above the load. Enclosed gears offer protection from dirt and debris.
For wire rope, see Wire Rope with Hook for Winches.
Note: Capacity is highest for the first layer of rope (at least five wraps of rope on the winch) and decreases as each additional layer of rope is wound on the winch.
Warning: Never use to lift people or items over people.
| Max. Cap., lbs. | Fully Wound Cap., lbs. | For Max. Rope Lg., ft. | For Rope Dia. | Base Wd. | Base Lg. | O'all Wd. | O'all Lg. | O'all Ht. | Handle Lg. | Hex Shank Size | For Max. Drill Speed, rpm | Duty Cycle @ Maximum Capacity | Material | Gear Speed Ratio | Each | |
| 2,000 | 1,200 | 77 | 1/4" | 6 5/8" | 7 1/4" | 11 1/2" | 13 1/2" | 8 1/2" | 11" | 1 1/8" | 400 | 15 Minutes On, 45 Minutes Off | Steel | 32:1 | 0000000 | 000000000 |
Drill-Wind Precise-Positioning Hand Winches for Wire Rope—For Horizontal Pulling
Remove the handle to wind these winches with a power drill.
For wire rope, see Wire Rope with Hook for Winches.
Note: Capacity is highest for the first layer of rope (at least five wraps of rope on the winch) and decreases as each additional layer of rope is wound on the winch.
| Max. Cap., lbs. | Fully Wound Cap., lbs. | For Max. Rope Lg., ft. | For Rope Dia. | Base Wd. | Base Lg. | O'all Wd. | O'all Lg. | O'all Ht. | Handle Lg. | Hex Shank Size | For Max. Drill Speed, rpm | Material | Gear Speed Ratio | Each | |
| 2,000 | 800 | 55 | 1/4" | 4 3/8" | 5 1/2" | 6" | 7 1/2" | 5 7/8" | 7" | 5/8" | 600 | Steel | 40.1:1 | 0000000 | 0000000 |