410 stainless steel is strong, wear resistant, and mildly chemical resistant.

These screws have the strength of 410 stainless steel with added corrosion resistance.

Made from stainless steel, these screws are more corrosion resistant than steel, and almost as strong.

With a drilling tip, these metric screws cut their own pilot hole and threads as you fasten them into material.

A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.

Stronger and more wear resistant than 18-8 stainless steel, these screws are mildly chemical resistant.

Drill a pilot hole, cut threads, and fasten in one motion with these metric-threaded screws. Made of steel, they’re strong and wear resistant.

The extra-wide truss head distributes holding pressure to reduce the risk of crushing thin metal.

Also known as pancake head screws, these have a head that is about two-thirds the height of standard rounded head screws.

These steel screws are available with corrosion resistant finishes. A rubber-bonded washer compresses to form a watertight seal. They save you time and effort by drilling their own holes and fastening in a single operation.

Known for their strength, these alloy steel screws are coated to provide corrosion resistance in wet environments.

One-third the weight of steel, aluminum screws resist corrosion in wet environments.

Beveled under the head for use in countersunk holes.

These screws have a free-rotating, permanently attached washer that remains stationary while tightening to prevent bunching while attaching tarps and other fabric to metal.

18-8 stainless steel screws have good chemical resistance.

Also known as Type 17 auger point screws, these penetrate hardwood and reduce driving torque. They require a pilot hole to prevent splitting when used near an edge.

Ribs under the head act as a brake to prevent over-tightening and damaging threads.

These square-drive screws have a drill point that powers through drywall and into metal studs up to 0.105" thick. Heads are one-third smaller than those of other drywall screws.