Plastic pins are a nonconductive and nonmagnetic alternative to metal dowel pins. Use them as pivots, hinges, shafts, jigs, and fixtures to locate or hold parts.

Oversized to fit worn and enlarged holes, these pins work well as repair and replacement parts.

Quarter-groove pins are well suited for hinges or pivots. The grooved end locks pins in position, while the smooth portion can act as a pivot. Also known as type C pins.

These pins make good hinges or pivots. The grooved half locks pins in position, while the smooth half can act as a pivot. Also known as type H pins.

Center-groove pins are often used in place of clevis pins or to create T-handles. The grooved center locks pins in position, while the smooth ends act as a pivot. Also known as type E pins.

Barbs bite into plastics and soft metals such as aluminum for a strong hold, and a round head gives a finished appearance.

Use these as pivot or hinge pins. The knurled half locks pins in position, while the smooth half acts as a pivot.

The full length of these pins is knurled for a tight grip that won't spin.

Made of compressed wood, these biscuits fit into slots cut into wood. When glued, they expand for a tight fit.

A spiral groove cut into these pins relieves trapped air but stays in 360° contact with the hole for a secure fit that's easy to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

For use with Browning shear hubs, these pins are designed to fail at specific loads to protect heavy duty machinery from torque overload.

Create a custom headed pin with your choice of material, dimensions, and end type.

To remove these pins, hit the small end with a punch to drive the pin out.

Threads on these pins stick out for easy removal from blind holes. Tighten the hex nut to draw the pin out.

Weld these pins directly to a surface —no mounting hole required.

These anchors are also known as drive rivets. To install, hammer the pin into the body. Pry out the pin to remove.

These anchors are also known as drive rivets. To install, hammer the screw into the body. Unthread the screw to remove.

A tamper-resistant nut prevents unwanted removal of the object you are anchoring.

These 316 stainless steel anchors have excellent resistance to chemicals and salt water.

You need access to only one side of the material to install these rivets.