Adapt metric dial indicators for use with standard inch-size contact points.

Mount one of these rods between the plunger and contact point to extend the reach of your indicator.

Remove the spindle cap on your Mitutoyo indicator and install a lever for easier lifting of the indicator spindle.

These indicators have a larger display than other Mitutoyo electronic indicators for easier reading.

These indicators come with a calibration certificate traceable to NIST that states they’ve passed a test for accuracy.

Check whether measurements are in tolerance at a glance. LCD backlighting changes from green to red to indicate when measurements fall outside your set tolerance.

A slim design fits in tight spots. These indicators have a spring-loaded plunger that retracts and extends to measure objects.

For use in wet environments, these indicators are IP53 rated for limited protection from dust and spraying water. A spring-loaded plunger retracts and extends to measure objects.

These indicators can display readings in fractional increments in addition to decimal increments.

For a solid mount on metal surfaces, these indicators come with a magnetic base. They have a continuous dial numbered clockwise around the face for direct measurements. A spring-loaded plunger retracts and extends to measure objects.

For comparative measurements of a part's tolerance against a reference measurement, these Starrett indicators have a balanced dial with positive values on one side and negative values on the other side.

These indicators come with a calibration certificate traceable to NIST that states they’ve passed a test for accuracy.

The contact point is located on the back of this indicator, which allows the dial face to be read from above. It has a continuous dial numbered clockwise around the face for direct measurements.

Use these indicators near magnetic chucks and other equipment with a magnetic field. Sets include a contact point adapter, swivel clamp, hole attachment, and mounting accessories.

These indicators come with a calibration certificate traceable to NIST that states they’ve passed a test for accuracy.

For direct measurements, these indicators have a continuous dial numbered clockwise around the face.

Take direct and comparative measurements with the same indicator. The combination dial has both a continuous scale numbered clockwise around the face and a balanced scale with positive values on one side of the zero and negative values on the other side.