Raise, transport, tilt, and drain full drums using the hook of a crane or hoist. A lock on each side of the frame keeps the drum vertical or horizontal during transport.

Drum adapters fit inside the saddle to hold 30-gallon drums.

Tilt brakes hold your drum in place if chain is released.

Fork pockets allow these lifters to be moved with a forklift.

Bracket kits for fiber and plastic drums bolt onto the side of the drum saddle and clamp to the top and bottom of the drum. They give the lifter enough stability to be used with rimless plastic and fiber drums.

Note: In half-full drums contents shift, which reduces capacity.

Warning: Never use to lift people or items over people.

Hook these lifters to a crane or hoist to pick up 5-gallon pails and pour out their contents. A hand wheel rotates the pail 360° in either direction, so you can easily dump adhesives, paint, or chemicals into containers without spilling or splashing. You can lock the wheel at any angle—in 45° increments—to control the flow of material. A bracket fits over the top of the pail to keep it from falling when it’s upended. These lifters also have a ratcheting strap to secure the center of the pail.

These lifters work with straight- or tapered-wall pails. Measure diameter at the pail’s midpoint.

Warning: Never use to lift people or items over people.

These dispensers mount to the forks of a forklift for lifting and transport, plus they pivot for manual tilting so dispensing is easy. The band clamps around the drum and is secured with a latch.

Warning: Never use to lift people or items over people.

Eliminate spills and splatter by rotating your closed drum to mix its contents. Motor is totally enclosed fan cooled (TEFC) for use in environments with splashing water and dust.

From the comfort of your forklift, just push a button to dispense heavy drums into large containers, vats, and hoppers. The battery-powered tilt offers greater precision than a manual tilt for a smoother, more controlled pour. You can rotate drums 180° in either direction. It takes about 15 seconds to fully invert them. On a single charge, you’ll be able to empty about 70 drums. These dispensers slide onto your forklift forks and secure with thumb screws. A chain with a ratchet-style tightener holds the drum in place.

Drum adapters fit inside the saddle to hold 30-gallon drums.

Bracket kits for fiber and plastic drums bolt onto the side of the drum saddle and clamp to the top and bottom of the drum. They give the dispenser enough stability to be used with rimless plastic and fiber drums.

Note: Contents shift in half-full drums, which reduces capacity.

Warning: Never use to lift people or items over people.

Motor is UL listed for use in environments with flammable gases and combustible dust. This mixer eliminates spills and splatter by rotating your closed drum to mix its contents.

With the push of a button, the electric hydraulic lift raises the drum and a chute controls the flow of the material being dispensed to prevent splashes and spills. A clamp on each side of the chute secures the drum. Handlers have a handheld pendant switch and operate only when the push-buttons are engaged. A limit switch turns off the motor when the drum reaches the maximum height. Load will not drop in the event of a power failure. Screw-down floor locks keep handlers stationary during operation.

Warning: Never use to lift people or items over people.