Use these bearings in applications with frequent starts and stops because they operate with very little friction.

PTFE bearings have good chemical resistance.

Rulon J bearings create the least amount of friction of any bearing that we offer. They handle heavier loads than PTFE bearings.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

Use where high loads and speeds are not required.

Acetal bearings have low moisture absorption and are more chemical resistant than nylon bearings.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

A steel backing adds strength to these slippery PTFE bearings.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

These bearings stand up to a wider range of chemicals than other dry-running thrust bearings. They are lightweight and strong.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.