An oversized diameter allows for finishing to your exact requirements.

Gray cast iron machines faster with less wear on cutting tools than most types of steel. It's often fabricated into gears, pulleys, rollers, and bushings.

Used for heavy cleaning and stripping, these discs have an abrasive-embedded nylon mesh construction that gives you more control over sanding pressure.

The premium abrasive stays sharp longer.

A coating prevents dust and debris from building up on the abrasive surface.

Used for stripping, these discs eliminate discoloration from heat buildup.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

These discs have a harder abrasive than standard flap sanding discs.

The backing plate on these discs can be sheared away as the abrasive flaps wear down, allowing you to use more of the disc rather than replacing with a new one.

Set at an angle and widely spaced, the flaps reach into corners.

Wheels are a blend of aluminum oxide and zirconia alumina, which removes more material and lasts three times as long as our General Purpose Grinding Wheels. They are also known as Type 27 wheels, raised-hub wheels, and grinding discs.

Use on 7" and 9" angle grinders and sanders to remove paint, rust, and scale from hard surfaces.

A more durable abrasive allows these wheels to remove more material and last longer than Norton General Purpose Grinding Wheels. They are also known as Type 1 wheels and straight wheels.

The special shapes of these wheels provide more clearance than typical straight wheels.

Made of aluminum oxide, these bits are well suited for use on most metals and materials that are not heat sensitive.

Use bits in any drill chuck that accepts a 1/4" hex shank.

Similar to diamond, boron nitride is harder than aluminum oxide and lasts longer. Bits are also known as jig grinding pins and mandrels.

Lap without the mess of pastes and slurries—abrasive is embedded in the surface of this waterproof film.

Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts in aluminum, iron, stainless steel, and steel.

Made of premium grade abrasives, these wheels are strong and thick for making notches in aluminum, iron, stainless steel, and steel.

These high-density ceramic oxide wheels have two layers of fiberglass mesh reinforcement and last up to twice as long as long-life cutoff wheels when cutting aluminum, iron, stainless steel, and steel.