Hold a workpiece securely from the side with minimal contact, leaving more of the workpiece free for machining.

Unlike the smooth and flat edges of standard fixture clamps, these clamps have ridges that bite into parts, making them good for gripping castings and rough-cut stock.

Machine these fixture clamps to match the contours of your workpiece for a stronger grip.

Machine these fixture clamps to match the contours of your workpieces for a stronger grip. Place the clamp between the two workpieces in a fixture and tighten the screw to extend the sides of the clamp, creating a secure hold against both workpieces.

Also known as toe clamps, these grip the side of a workpiece to leave the top free for machining.

The stepped end provides support and quick height adjustment when paired with a step block.

Three screws apply pressure to three sides of a workpiece.

Push or pull the plunger to hold your workpiece from the side.

Pull the handle backward to push the plunger forward. These clamps secure when the plunger is fully extended to hold your workpiece from the side.

The handle can be rotated 125° for easier access or extra clearance above the clamp.

Secure your workpiece from the side by fully extending the plunger, and push a lever to lock the handle in place.

Moving parts are sealed to prevent dirt and dust from clogging the clamp.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

The plunger can be locked at any position along its travel.