A galvanized finish gives these fittings better corrosion resistance than our plain steel high-pressure fittings. Also known as Pressure Class 3000 fittings.

Made to tighter tolerances than other steel pipe fittings, these are also known as instrumentation fittings.

For use in noncorrosive environments, these fittings have better strength than our low-pressure iron and steel pipe fittings.

Crimp these fittings onto steel pipe to form a tightly sealed connection that’s faster than threading or welding and doesn’t require heat.

Socket-connect fittings are easier to weld than butt-weld fittings because the fitting doesn't need to align perfectly to the pipe. Slide the pipe into the socket and weld.

Also known as JIC (Joint Industrial Council) fittings, these provide a tight metal-to-metal seal on steel tubing that is flared to 37°.

A single sleeve (ferrule) bites into tubing as you tighten the nut, creating a strong seal.

Thicker walls make these fittings—sometimes called flareless or bite fittings—withstand about twice as much pressure as standard compression fittings, so they’re good for hydraulic power applications.

A tube adapter sits flush against the flat face of the fitting so you can slide the steel tubing and fitting sideways to disconnect in cramped spaces. Also known as zero-clearance fittings.

A single rounded bead grips onto hose just like a barb, but has no sharp edges that could cut or damage soft hose. Slide the beaded end into hose and secure with a clamp. Use in coolant applications up to 300 psi.

Also known as live swivels, these fittings swivel continuously 360° before and after installation. This not only makes installation easier, but also eliminates the twisting and kinking that can cause hose failure. Fittings are threaded on both ends so you can connect them directly to a threaded hose or to pumps, cylinders, and other equipment in your hydraulic system. Use in high-pressure applications up to 5,000 psi.

Join pieces of conduit.

Gaskets on the covers and at connection points protect against dust as well as seeping oil and coolant.

Route power, data, and control cable rated up to 600 volts AC/DC.

Join duct and fittings with quick-release clamps for faster disassembly and cleanout than other duct systems.

Fittings have gaskets which create a tight seal—you don't need to seal joints with coating or tape.

For use with gas-fired equipment, such as boilers and furnaces, these vent pipes and fittings withstand temperatures up to 400° F. Also known as type B gas vents.

Create strong structures by welding this framing together. Add metal panels to close off openings.