Extra-thick walls provide more protection against abrasion and tears than standard high-shrink-ratio tubing. This tubing shrinks down to 1/6th of its original ID, so it creates a tight seal over irregularly shaped objects.

The smallest heat-shrink tubing we offer, this tubing protects wire with a 0.017" and smaller diameter.

Access connections more easily than with standard heat-shrink tubing. Make a small slit in this tubing to peel it away.

Extra-thick walls provide better protection against abrasion and tears than standard moisture-seal tubing, as well as creating a water-resistant seal.

This PTFE tubing withstands temperatures up to 450° F and has an inner lining that creates a water-resistant seal when heated.

Create a tight, water-resistant seal over irregularly shaped components. When heated, this tubing shrinks down to about 1/6th of its original ID, while an adhesive lining melts and forms a barrier around your component.

Resistant to diesel fuel, gasoline, hydraulic fluid, and lubricating oil, this tubing is often used in vehicles.

Insulate and protect high-voltage devices. This tubing withstands higher voltages than standard heat-shrink tubing because it’s made of a flame-retardant material with excellent electrical insulation properties.

This tubing shrinks down to a quarter of its original ID, so it creates a tight seal over irregularly shaped objects. It withstands up to 500° F.

With excellent durability and chemical resistance, this tubing withstands demanding use.

Also known as halogen-free tubing, this tubing produces minimal amounts of smoke and gas if exposed to an open flame, so it can be used in enclosed areas such as ships and tunnels.

Protect light bulbs, capacitors, and other electronics—this FEP tubing adds a tear- and cut-resistant layer that even contains shattered glass if the bulb breaks.

Often used in automated applications such as robotics, this highly flexible silicone rubber tubing withstands continuous motion without cracking and tearing. It resists abrasion and can be dragged over rough surfaces without damage.

Even with walls as thin as tracing paper, this PET plastic tubing withstands tears and nicks. Thanks to its thin walls, it shrinks down in seconds instead of minutes and at lower temperatures than PVDF and FEP plastic tubing.

Keep general purpose tubing in a variety of sizes on hand.

Seal the end of crimped connections, such as motor coils, to insulate and protect them from moisture and abrasion.

A different shrink ratio on each end allows this tubing to fit over cable assemblies and wire harnesses with large connections, or around connectors with a 90° elbow.

Create a permanent seal without applying heat. This tubing is also known as cold-shrink tubing.

With a spiral-wound core, these end caps form a permanent seal on the end of your crimped wire or cable without heat or tools.

Also known as cable-entry seals, the cable-entry side has heat-shrinkable polyolefin with an adhesive lining.

Apply heat and these grommets shrink around wire, cable, and cords to keep out dust, debris, and moisture.