Lockout works with most 120V AC circuit breakers that have a hole through the breaker lever.

Secure a single breaker switch with multiple padlocks, so electricity stays safely off until everyone's done working.

Use the push-button end to easily install this lockout on circuit breakers with pin lockout holes on the outside of the circuit-breaker toggle switch that are mounted on DIN rails.

Place a plug into the cylinder and padlock so the plug can't be used.

Same as our other low-profile lockout hasps, but with an attached label to record employee name and department.

Lockouts come in different colors for easy identification and to help meet OSHA standards. The label is permanently attached to record employee name and department.

Like two lockout hasps in one, there's a jaw at each end with different clearances for added versatility.

With a smaller overall length, these lockout hasps fit in tighter spaces than other lockout hasps yet still hold a similar number of locks.

The fold-over closing design hinders prying, while a slot instead of holes makes it easy to install multiple padlocks.

In addition to an overlapping hasp that interlocks when closed, lockouts have a chain that attaches to equipment so they won't get lost.

After locking, pull the cable tight for a secure fit.

Thread the free end of the cable through the looped end and into the lockout clamping hole; pull tight and close handle to pinch the cable for a secure fit.

Prevent cranes, hoists, and other machinery controlled by pendant switches from starting up during maintenance.

In addition to a hasp that interlocks when closed, lockout has an adapter to lock out a valve and a chain that attaches to equipment so it won't get lost.