Use this rubber tape to splice cable in high-voltage applications.

No need for adhesive—this tape fuses to itself for a permanent seal and stretches to fit virtually any form. Also known as cold shrink tape.

This traditional black cotton electrician's tape provides an abrasion-resistant shield for wrapping low-voltage splices.

At only 0.0025" thick, this tape combines conformability with durability and abrasion resistance.

In the event of a fire, this rubber tape expands to protect cables from flames and heat.

More conformable than copper foil electrical tape, this tape bonds to textured electronic housings, round cables, and other curved and irregular surfaces. Since it doesn’t leave gaps, it’s a great shield against electromagnetic interference (EMI).

This polyester tape has a woven mesh edge that conducts electricity. Use it to shield cables and electronic components from EMI (electromagnetic interference).

Tested to meet ASTM E595, a standard used by NASA, this tape releases almost no volatile emissions that could damage sensitive electronics, even in a vacuum. Use it to repair and prototype circuit boards and shield components from EMI/RFI.

A coating on this polyimide tape minimizes ESD (electrostatic discharge) when unwound from the roll and also during removal.

Use this tape to attach components to heat sinks and metal chassis walls in place of screws and other mechanical fasteners. It conducts heat away from sensitive electronics.

Use these convenient cut shapes to mask holes, fastener heads, and small areas while soldering.

Providing all-weather corrosion protection, this vinyl tape resists salt water, UV light, acids, and alkalies. Use it to wrap pipes and electrical conduit both above and below ground.

Seal out light to mask LEDs and prevent backlight bleed on LCD monitors with this opaque polyester tape.

Our most slippery tape, the slick surface allows items to glide smoothly over it.

Low-Friction Tape Shapes Made with Teflon® PTFE.

Backed with 3M VHB 4941 foam adhesive for strength, padding, and vibration resistance.

PEEK offers the best wear and abrasion resistance of our low-friction tapes. Use it for wire wraps and sliding bearing surfaces.

Telecom characters repeat on these markers so you can wrap them around various-sized wires.

These books have messages used in electrical systems such as AC and DC.

Dispensers make it quick and easy to remove the markers you need.

Choose a range of characters. The characters repeat on these markers so you can wrap them around various-sized wires.

Write a message on these blank markers with a permanent marker, then wrap them around wire or cables.