Rated for use in damp locations, these lights withstand humidity and moisture.

These lights are sealed to protect against humidity, moisture, and dripping and splashing liquids.

These lights are UL rated for use in hazardous locations where flammable/combustible gases, vapors, and liquids may be present.

Plug in these rechargeable flashlights and they’ll automatically light up when the power goes out.

These flashlights are built to handle everyday use. They have a slip-resistant grip to ensure a secure hold.

The handle opens into a tripod, so you can shine light on your work while keeping your hands free.

Tilt the head on these flashlights to aim light exactly where it's needed. They have a flat bottom, so you can work hands-free without them rolling away.

Made of stainless steel, these pocket-size flashlights have a smooth, easy-to-clean surface.

Extend light into hard-to-reach spaces by attaching a fiber-optic cable to your flashlight.

Securely store your flashlight when not in use.

Turn your mini flashlight into an illuminated magnifying glass.

Rated for use in environments where hazardous material is present.

Clip these little flashlights to any surface up to 1/2” thick and keep your hands free for work. They're rated for use in environments where hazardous material is present.

All of these flashlights stand up to wet environments.

Keep your hands free by wearing a flashlight on your head.

Turn a mini flashlight into a headlamp with these straps.

Twist the base to turn these reusable lightsticks on and off.

Use sun energy to bring light to remote areas and storage spaces without electrical wiring. These lights come with a solar panel to recharge their battery.

Because these lights are compatible with DeWalt rechargeable batteries, you can keep one type of cordless tool battery on hand. Their heads pivot to aim light where it's needed in areas that don't have electrical power service.

A flexible design allows these lights to be suspended above, wrapped around, or routed through areas on the job site.

Keep excess cord out of the way—the reel locks the cord at any length and retracts it when not in use.

Use these with portable lights that use screw-in bulbs.

These IP67 rated lights withstand temporary submersion in a maximum of one meter of water for up to 30 minutes. They're compact for easy transport to job sites with no electrical power.

Compact and easy to carry, these IP65-rated lights stand up to dust and low-pressure jets of water. The head adjusts up and down as well as side to side to direct light where it's needed.

Heads adjust to any angle so you can direct light where needed.

Illuminate outdoor areas and objects such as parking lots, flag poles, and billboards.

Powered by the sun, these security lights function in areas that don’t have access to electricity. They’re often used to shine light on parking lots, landscaping, signs, entryways, and other outdoor spaces.

Illuminate exits during power failures and other emergencies—these signs have battery-powered emergency lights. The backlit message meets UL 924 regulations for visibility.

These signs are lit from within for high visibility. They meet UL 924 regulations for visibility.

These lights are UL listed for environments where fuels, solvents, acetylene, and other hazardous substances may be present.

These lights cycle through three different flashing patterns.

These lights cycle through three different flashing patterns.

Quickly position these portable flashing lights using the magnetic base to draw attention to hazards in areas such as docks and railroad crossings. They are battery operated, so they do not need to be wired or plugged in.

A series of four flashes per cycle makes these lights more visible than other strobe lights.

As small as a hockey puck and compatible with standard 12-volt vehicle plugs, these strobe lights are inconspicuous when not in use and quick to connect.

Set these portable lights wherever you need a signal light—they don't need to be wired or plugged in.

Screw into a standard medium-base light socket.

These lights can switch between being continuous or flashing.

These lights can switch between continuous, flashing, or revolving.

The buzzer warns workers of hazards even when they’re outside a direct line of sight.

Lights combine high-visibility strobes with a buzzer that warns workers of hazards even when they’re outside a direct line of sight.

These lights have lenses that snap in and out, so you can easily swap colors or change their position in the stack.

Choose from seven colors, including nontraditional colors such as magenta and turquoise, for a custom four-light stack light.

Design a stack light with your choice of light pattern and color. Start with a base, then add up to five modules total—twist and lock them together.

The quick-connect four-pole M12 plug on these lights makes them easy to hook up and configure.

Give a signal with the push of a button. These lights have a control box for activating each of the three light modules.

Good for tight spaces where a tower of lights won't fit, these emit three colors from a single lens.

These bulbs are sized to fit tight spaces such as indicators and vehicle lights.

These miniature bulbs are sized to fit older telephone switchboards, signs, instruments, and indicators.

Offset pins on the base lock these bulbs into sockets. One pin is slightly higher on the base than the other pin.

These bulbs are sized to fit tight spaces such as signs, control panels, indicators, and flashlights.

Prongs on the side of the base plug in to specialty track lighting fixtures.

These bulbs have a bi-pin connection to lock into sockets.

Replace bayonet base incandescent bulbs in exit signs with longer-lasting, energy-efficient LEDs.