A padlock locks the handle of these valves in the shut-off position so you can disconnect air tools safely.

With two 2-way integrated solenoid valves, these electrically controlled valves direct airflow to venturi pumps, which generate the suction you need to run end-of-arm tools, such as vacuum cups.

Use a single valve to create motion and control the speed of that motion.

These valves close all ports in the off position to stop equipment in a locked position with air pressure holding it in place. Often used to extend and then retract a cylinder at different speeds, they create two actions and have two exhaust ports, which allows you to control the speed of each action by attaching a flow control valve to each exhaust port. Apply voltage to the electrical connection to actuate.

These valves are rated for environments where hazardous material is present. They actuate when voltage is applied to the electrical connection.

In the off position, these valves stop equipment in a locked position with air pressure holding it in place. Often used to extend and then retract a cylinder at different speeds, they create two actions and have two exhaust ports, which allows you to control the speed of each action by attaching a flow control valve to each exhaust port. They actuate by air signal, so they're good for environments where electrical use may be dangerous.

Also known as Monday-morning valves, these valves slowly introduce pressure to reduce surge damage during start-up.

Also known as Monday-morning valves, these valves slowly introduce pressure to reduce surge damage during start-up.

Prevent accidental start-up when servicing equipment.

These solenoid valves operate on electricity to automatically start and stop flow. The actuator is directly mounted to the valve body to minimize movement and reduce wear.

Control flow in high-pressure lines in tight spots—these valves have the highest pressure ratings of our compact valves.

Lower profile and available in smaller connection sizes than standard valves, these fit in tight spots.

Less than half the size of our other compact valves, these have small pipe connections for miniature lines.

Avoid pressure surges and system shocks that can damage piping by installing these valves that open and close slowly.

Safe for automated on/off control in drinking-water systems, these valves meet NSF/ANSI Standard 61.

A built-in strainer traps debris and allows you to replace the screen without disconnecting your pipeline.

Sturdy internal components resist wear for a long service life in applications with frequent cycling.

Built to withstand the extreme cold of liquid nitrogen and liquid oxygen, these valves are cleaned and bagged for high-purity applications.

Insert tubing into the fittings on these valves—no heat, solder, or flux required.

With a plastic body and a fluoroelastomer seal, these valves can stand up to aggressive and corrosive solutions in chemical-processing applications.

Limit wear and damage in high-cycling applications—these valves have additional seals that prevent leakage to reduce maintenance time.

For use in general purpose applications with water, oil, and inert gas.

Less than half the height of standard severe-duty valves, these fit in small spaces and low-clearance pipelines.

About half the height of our other versa-mount valves, these fit in tight spots.

Also known as butterfly valves.

Use these valves to safely transfer fuel and oil.

With a ball-valve design, these valves can handle three times the flow of butterfly valves.

Also known as piston valves, these have a compact, lightweight actuator that allows them to be installed in any mounting orientation. They’re often used in water-treatment applications.

For food and beverage systems that require frequent cleaning, these valves have polished internal surfaces and sanitary quick-clamp connections for easy disassembly.

Insert unthreaded pipe into the socket ends and bond with PVC primer and cement to create a permanent, leak-tight connection.

These valves have threaded NPT connections.

For three times the flow of butterfly valves, these have a ball valve design.

With a slimmer motor than other motor-driven valves, these fit in tight spots.

Their ball valve design allows these valves to handle three times the flow of butterfly valves.

The motor on these valves can handle diverting applications with high flow rates and pressures. They operate on electricity to automatically divert flow between ports.