Use this shielded sleeving to protect wire and cable from signal distortion caused by nearby equipment and devices. A sewn-in ground wire dissipates any stored charge. It provides good protection against abrasion. Wrap it around wire and cable without disconnecting them; sleeving has a slit along the entire length.

Sleeving with an overlap closure wraps over itself and stays closed without an adhesive strip or other closure, so it can be removed and reused. Sleeving with an adhesive strip closure is permanently sealed when the adhesive is applied.

Sleeving with copper wire shielding is ultra-flexible, so it’s good for applications that require tight turns. Sleeving with foil shielding is for use in stationary applications. Repeated flexing will damage the foil.

Polyester fabric sleeving has good abrasion and tear resistance. Polyurethane rubber sleeving provides excellent resistance to solvents.

Flame rated VW-1 sleeving meets requirements for preventing the spread of flames based on a timed test with vertically suspended material.

Often used to protect wire, cable, and hose in robotics and other automated applications, this highly flexible sleeving withstands continuous motion without tearing or fraying. It can even be used over cable and hose carriers for an added layer of protection. This sleeving opens along its entire length, so there’s no need to disconnect lines or use tools for maintenance such as adding or removing cable.

Polyurethane sleeving has a conductive cloth lining that shields against signal interference caused by nearby equipment and devices. A sewn-in ground wire dissipates any stored charge. The adhesive strip closure seals permanently, so you’ll need to replace this sleeving if you open it. This sleeving resists oil and grease.

PVC fabric sleeving has a chemical-resistant polyester coating, so it’s commonly used to protect wire in areas where painting or sealing takes place. A hook-and-loop closure allows access for maintenance at any point. Elastic on both ends holds sleeving in place.

Leather sleeving has excellent abrasion resistance, making it a good choice for applications where sleeving will make contact with other objects. For easy maintenance, a zipper closure lets you access the sleeving at all points. Hook-and-loop closures at either end of the sleeving secure it in place.

Kevlar aramid sleeving resists temperatures up to 1000° F. Use it to protect wire near furnaces, in welding areas, and in other extremely hot environments. This sleeving has good abrasion resistance, a zipper closure for easy maintenance, and hook-and-loop straps on each end to hold sleeving in place.