Search Results
    Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    0.01"
    Number of Flutes
    Number of Flutes
    23
    4
    Cut Style
    Cut Style
    SquareBall
    Length of Cut
    Length of Cut
    0.015"
    0.03"
    0.05"
    Shank Diameter
    Shank Diameter
    default
    1/8"
    Material
    Material
    Carbide
    Number of Milling Ends
    Number of Milling Ends
    1
    End Mill Type
    End Mill Type
    Center Cutting
    Helix Angle
    Helix Angle
    30°
    Overall Length
    Overall Length
    1 1/2"
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Flute Type
    Flute Type
    Spiral
    Shank Type
    Shank Type
    Round
    Flute Spacing
    Flute Spacing
    Equal
    Individual/Set
    Individual/Set
    Individual
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    17 Products