Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    1 1/2"
    Shank Diameter
    Shank Diameter
    default
    1/2"
    3/4"
    1"
    1 1/4"
    Number of Flutes
    Number of Flutes
    24
    68
    Length of Cut
    Length of Cut
    1/2"
    3/4"
    1 1/8"
    1 1/2"
    1 5/8"
    2"
    2 1/4"
    4"
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Cutting Angle
    Cutting Angle
    30°
    45°
    60°
    Shank Type
    Shank Type
    RoundR8 Taper
    Cut Radius
    Cut Radius
    1/4"
    3/8"
    1/2"
    Number of Milling Ends
    Number of Milling Ends
    1
    Individual/Set
    Individual/Set
    Individual
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Flute Spacing
    Flute Spacing
    Equal
    Flute Type
    Flute Type
    Spiral
    Straight
    Helix Angle
    Helix Angle
    30°
    38°
    Arbor Hole Diameter
    Arbor Hole Diameter
    1/2"
    Neck Diameter
    Neck Diameter
    0.31"
    0.44"
    0.47"
    0.49"
    5/8"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    89 Products