Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    1 1/4"
    Shank Diameter
    Shank Diameter
    default
    1/2"
    5/8"
    3/4"
    7/8"
    1"
    1 1/4"
    Number of Flutes
    Number of Flutes
    24
    68
    Length of Cut
    Length of Cut
    1/4"
    1/2"
    3/4"
    1 1/8"
    1 1/2"
    1 5/8"
    2"
    3"
    4"
    6"
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Cut Radius
    Cut Radius
    1/8"
    1/4"
    3/8"
    Shank Type
    Shank Type
    RoundR8 Taper
    Individual/Set
    Individual/Set
    Individual
    Number of Milling Ends
    Number of Milling Ends
    1
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Flute Type
    Flute Type
    Spiral
    Straight
    Flute Spacing
    Flute Spacing
    Equal
    Arbor Hole Diameter
    Arbor Hole Diameter
    1/2"
    Helix Angle
    Helix Angle
    30°
    For T-Slot Bolt Size
    For T-Slot Bolt Size
    5/8"
    Number of Teeth
    Number of Teeth
    8
    24
    28
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    80 Products