Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    1 1/8"
    Shank Diameter
    Shank Diameter
    default
    1/2"
    5/8"
    3/4"
    7/8"
    1"
    Number of Flutes
    Number of Flutes
    24
    68
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Length of Cut
    Length of Cut
    3/4"
    1 1/8"
    1 1/2"
    1 5/8"
    2"
    4"
    Number of Milling Ends
    Number of Milling Ends
    1
    Individual/Set
    Individual/Set
    Individual
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Shank Type
    Shank Type
    Round
    Flute Spacing
    Flute Spacing
    Equal
    Flute Type
    Flute Type
    Spiral
    Straight
    Helix Angle
    Helix Angle
    30°
    Chamfer Angle
    Chamfer Angle
    60°
    Cut Radius
    Cut Radius
    5/16"
    Cutting Angle
    Cutting Angle
    30°
    45°
    For Maximum OD
    For Maximum OD
    3/4"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    51 Products