Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    1 3/4"
    Cut Style
    Cut Style
    SquareConvex Radius
    Gear
    Shank Diameter
    Shank Diameter
    default
    3/4"
    1 1/4"
    Number of Flutes
    Number of Flutes
    24
    6
    Length of Cut
    Length of Cut
    3/4"
    1 1/2"
    1 5/8"
    2"
    Material
    Material
    High-Speed Steel
    Steel
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Overall Length
    Overall Length
    3 7/8"
    4"
    4 1/8"
    4 1/4"
    4 1/2"
    5 7/8"
    For Number of Gear Teeth
    For Number of Gear Teeth
    12-13
    14-16
    17-20
    21-25
    26-34
    35-54
    55-134
    135 and Up
    For Gear Pitch
    For Gear Pitch
    24
    32
    48
    Cut Radius
    Cut Radius
    3/8"
    Individual/Set
    Individual/Set
    Individual
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    For Gear Type
    For Gear Type
    Pinion
    Spur
    Shank Type
    Shank Type
    RoundR8 Taper
    Number of Milling Ends
    Number of Milling Ends
    1
    Flute Spacing
    Flute Spacing
    Equal
    Flute Type
    Flute Type
    Spiral
    Straight
    Helix Angle
    Helix Angle
    30°
    Cutter Trade Number
    Cutter Trade Number
    1
    2
    3
    4
    5
    6
    7
    8
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    37 Products