Choose a Category
    Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    1/32"
    Cut Style
    Cut Style
    SquareBall
    Tapered
    Number of Flutes
    Number of Flutes
    23
    4
    Shank Diameter
    Shank Diameter
    default
    1/8"
    3/16"
    Length of Cut
    Length of Cut
    3/64"
    1/16"
    5/64"
    3/32"
    5/32"
    1/4"
    1/2"
    Number of Milling Ends
    Number of Milling Ends
    1
    2
    End Mill Type
    End Mill Type
    Center Cutting
    Overall Length
    Overall Length
    1 1/2"
    2"
    2 1/4"
    2 1/2"
    Shank Type
    Shank Type
    Round
    Individual/Set
    Individual/Set
    Individual
    Flute Spacing
    Flute Spacing
    Equal
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Flute Type
    Flute Type
    Spiral
    Helix Angle
    Helix Angle
    30°
    33°
    35°
    40°
    Maximum Taper Diameter
    Maximum Taper Diameter
    1/16"
    Taper Angle per Side
    Taper Angle per Side
    Taper End Style
    Taper End Style
    Square End
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    63 Products