Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    1"
    Shank Diameter
    Shank Diameter
    default
    1/2"
    5/8"
    3/4"
    1"
    Number of Flutes
    Number of Flutes
    2
    3
    4
    5
    6
    8
    10
    11
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Number of Milling Ends
    Number of Milling Ends
    1
    2
    Shank Type
    Shank Type
    RoundR8 Taper
    Individual/Set
    Individual/Set
    Individual
    Flute Spacing
    Flute Spacing
    Equal
    Variable
    Flute Type
    Flute Type
    Spiral
    Straight
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Cutting Angle
    Cutting Angle
    45°
    60°
    90°
    Cut Radius
    Cut Radius
    1/8"
    5/32"
    3/16"
    1/4"
    Corner Cut Radius
    Corner Cut Radius
    0.03"
    Flute Pitch
    Flute Pitch
    Coarse
    Fine
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    215 Products