Clear All
    System of Measurement
    System of Measurement
    Metric
    Mill Diameter
    Mill Diameter
    Show
    10mm
    Number of Flutes
    Number of Flutes
    23
    45
    67
    Shank Diameter
    Shank Diameter
    default
    9.5mm
    10mm
    12mm
    12.7mm
    Number of Milling Ends
    Number of Milling Ends
    1
    2
    Overall Length
    Overall Length
    64mm
    68mm
    70mm
    72mm
    80mm
    82mm
    100mm
    105mm
    110mm
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Individual/Set
    Individual/Set
    Individual
    Shank Type
    Shank Type
    Round
    Flute Spacing
    Flute Spacing
    Equal
    Variable
    Flute Type
    Flute Type
    Spiral
    Straight
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    Cutting Angle
    Cutting Angle
    60°
    82°
    90°
    For Maximum Hardness
    For Maximum Hardness
    Rockwell C52
    Flute Pitch
    Flute Pitch
    Coarse
    Fine
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    61 Products