Search Results
    Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    2 1/4"
    Cut Radius
    Cut Radius
    3/4"
    Arbor Hole Diameter
    Arbor Hole Diameter
    7/8"
    1"
    Shank Diameter
    Shank Diameter
    default
    3/4"
    Cutting Angle
    Cutting Angle
    30°
    60°
    90°
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Mill Thickness
    Mill Thickness
    0.315"
    1/2"
    1 1/2"
    2 15/16"
    Individual/Set
    Individual/Set
    Individual
    Finish
    Finish
    Uncoated
    Number of Milling Ends
    Number of Milling Ends
    1
    For Gear Pitch
    For Gear Pitch
    12
    For Number of Gear Teeth
    For Number of Gear Teeth
    12-13
    14-16
    17-20
    21-25
    26-34
    35-54
    55-134
    135 and Up
    Number of Flutes
    Number of Flutes
    4
    Overall Length
    Overall Length
    3 1/8"
    4 1/8"
    Shank Type
    Shank Type
    Round
    For Gear Type
    For Gear Type
    Pinion
    Spur
    Tip Diameter
    Tip Diameter
    5/8"
    Flute Spacing
    Flute Spacing
    Equal
    Flute Type
    Flute Type
    Straight
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    15 Products