Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    3/16"
    Number of Flutes
    Number of Flutes
    12
    34
    57
    Shank Diameter
    Shank Diameter
    default
    3/16"
    1/4"
    3/8"
    1/2"
    5/8"
    Number of Milling Ends
    Number of Milling Ends
    1
    2
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Individual/Set
    Individual/Set
    Individual
    Flute Type
    Flute Type
    Spiral
    Straight
    Intersecting
    Shank Type
    Shank Type
    Round
    Flute Spacing
    Flute Spacing
    Equal
    Variable
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Taper Angle per Side
    Taper Angle per Side
    1/2°
    1 1/2°
    10°
    15°
    20°
    Corner Cut Radius
    Corner Cut Radius
    0.008"
    0.01"
    0.015"
    0.02"
    0.03"
    Cutting Angle
    Cutting Angle
    30°
    60°
    82°
    90°
    120°
    Cut Radius
    Cut Radius
    1/32"
    1/16"
    Taper End Style
    Taper End Style
    Square End
    Ball End
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    264 Products