Clear All
    System of Measurement
    System of Measurement
    Metric
    Mill Diameter
    Mill Diameter
    Show
    3mm
    Number of Flutes
    Number of Flutes
    23
    45
    6
    Shank Diameter
    Shank Diameter
    default
    3mm
    6mm
    8mm
    9.5mm
    10mm
    12mm
    Number of Milling Ends
    Number of Milling Ends
    1
    2
    End Mill Type
    End Mill Type
    Center Cutting
    Shank Type
    Shank Type
    Round
    Individual/Set
    Individual/Set
    Individual
    Flute Spacing
    Flute Spacing
    Equal
    Variable
    Flute Type
    Flute Type
    Spiral
    Straight
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    Taper Angle per Side
    Taper Angle per Side
    10°
    15°
    20°
    25°
    30°
    For Maximum Hardness
    For Maximum Hardness
    Rockwell C52
    Maximum Taper Diameter
    Maximum Taper Diameter
    3.7mm
    4.4mm
    5.6mm
    6.4mm
    10.1mm
    11.7mm
    14.2mm
    16.4mm
    16.8mm
    16.9mm
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    65 Products