Search Results
    Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    5/32"
    Number of Flutes
    Number of Flutes
    23
    45
    Length of Cut
    Length of Cut
    15/64"
    5/16"
    7/16"
    1/2"
    9/16"
    3/4"
    7/8"
    1 3/4"
    Number of Milling Ends
    Number of Milling Ends
    1
    2
    Shank Diameter
    Shank Diameter
    default
    3/16"
    3/8"
    End Mill Type
    End Mill Type
    Center Cutting
    Overall Length
    Overall Length
    2"
    2 1/4"
    2 5/16"
    3 1/8"
    3 1/4"
    3 1/2"
    Helix Angle
    Helix Angle
    15°
    28°
    30°
    33°
    35°
    45°
    Individual/Set
    Individual/Set
    Individual
    Flute Type
    Flute Type
    Spiral
    Intersecting
    Shank Type
    Shank Type
    Round
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Flute Spacing
    Flute Spacing
    Equal
    Corner Cut Radius
    Corner Cut Radius
    0.01"
    Taper Angle per Side
    Taper Angle per Side
    Taper End Style
    Taper End Style
    Ball End
    Flute Pitch
    Flute Pitch
    Coarse
    Fine
    Maximum Taper Diameter
    Maximum Taper Diameter
    3/8"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    82 Products