Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    Show
    7/8"
    Number of Flutes
    Number of Flutes
    23
    45
    6
    Shank Diameter
    Shank Diameter
    default
    1/2"
    5/8"
    3/4"
    7/8"
    Number of Milling Ends
    Number of Milling Ends
    1
    2
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Individual/Set
    Individual/Set
    Individual
    Shank Type
    Shank Type
    Round
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Flute Spacing
    Flute Spacing
    Equal
    Cut Radius
    Cut Radius
    3/32"
    3/16"
    Flute Type
    Flute Type
    Spiral
    Straight
    Helix Angle
    Helix Angle
    30°
    38°
    Mill Thickness
    Mill Thickness
    5/32"
    3/16"
    7/32"
    1/4"
    1 5/16"
    Neck Length
    Neck Length
    1/4"
    3/8"
    1/2"
    Neck Diameter
    Neck Diameter
    1/4"
    0.28"
    0.34"
    3/8"
    0.437"
    For Maximum OD
    For Maximum OD
    1/2"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    87 Products