Search Results
    Clear All
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    default
    3/16"
    1/4"
    3/8"
    Cut Style
    Cut Style
    Square
    Number of Flutes
    Number of Flutes
    Show
    7
    Number of Flutes
    Number of Flutes
    Hide
    1
    2
    3
    4
    5
    6
    7
    8
    9
    10
    11
    Shank Diameter
    Shank Diameter
    default
    3/16"
    1/4"
    3/8"
    Length of Cut
    Length of Cut
    5/8"
    3/4"
    1"
    Material
    Material
    Carbide
    Number of Milling Ends
    Number of Milling Ends
    1
    Overall Length
    Overall Length
    2"
    2 1/2"
    3"
    End Mill Type
    End Mill Type
    Center Cutting
    Flute Type
    Flute Type
    Spiral
    Helix Angle
    Helix Angle
    35°
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Flute Spacing
    Flute Spacing
    Equal
    Individual/Set
    Individual/Set
    Individual
    Shank Type
    Shank Type
    Round
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    3 Products

    Carbide Square End Mills