System of Measurement System of Measurement |
|---|
|
Thread Size Thread Size |
|---|
|
Finish Finish | Show |
|---|
|
Finish Finish | Hide |
|---|
Appearance Appearance |
|---|
|
For Window Type For Window Type |
|---|
|
Mounting Hole Center-to-Center Mounting HoleCenter-to-Center |
|---|
|
Mounting Screw Length Mounting Screw Length |
|---|
|
Head Type Head Type |
|---|
 | Flat |
Drive Style Drive Style |
|---|
 | Phillips |
Tapping Screw Type Tapping Screw Type |
|---|
 | F |
Tip Type Tip Type |
|---|
 | Blunt |
For Use In For Use In |
|---|
|
Screw Size Screw Size |
|---|
|
Bead Diameter Bead Diameter |
|---|
|
Flat Head Profile Flat Head Profile |
|---|
 | Undercut |
Tag Holder Type Tag Holder Type |
|---|
 | Ring |
About Tapping Screws
More
Hinge Screws
Commonly used with door hinge hardware, these screws cut threads in soft material such as aluminum and brass. They're beveled under the head for use in countersunk holes. They are undercut to allow more threading. Screws cut threads in drilled holes as they’re turned, so they require less driving torque and cause less stress on your material than thread forming screws. Length is measured from the top of the head.
Brass, bronze, and chrome-plated steel screws have a bright and attractive finish. They're corrosion resistant in wet environments.
For technical drawings and 3-D models, click on a part number.
Head | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| Material | Thread Size | Lg. | Dia. | Ht. | Drive Size | Drill Bit Size | Tapping Screw Type | For Use In | Pkg. Qty. | Pkg. | |
| Brass-Plated Steel | 12-24 | 1/2" | 0.412" | 0.092" | No. 3 | No. 8 | F | Aluminum, Brass, Sheet Metal | 10 | 000000000 | 00000 |
Window Latches
For technical drawings and 3-D models, click on a part number.
Mounting Hole | |||||
|---|---|---|---|---|---|
| Mounting Fasteners Included | Dia. | Ctr.-to-Ctr. | For Window Type | Each | |
Brass-Plated Aluminum—Dull | |||||
| Yes | 3/16" | 1 15/16" | Double Hung, Single Hung | 000000 | 00000 |
Latches for Swing-Open Windows
Often used on casement windows, this latch includes a surface strike plate and a mortise strike plate.
For technical drawings and 3-D models, click on a part number.
Mounting Plate | Edge-Mount Strike Plate | Mortise-Mount Strike Plate | |||||||
|---|---|---|---|---|---|---|---|---|---|
| Ht. | Wd. | Ht. | Wd. | Ht. | Wd. | Mounting Fasteners Included | Mounting Hole Dia. | Each | |
Brass-Plated Steel—Dull | |||||||||
| 2 1/16" | 7/8" | 1 5/8" | 1 5/8" | 2 1/2" | 13/16" | Yes | 1/8" | 000000 | 000000 |