Extrude melted filament onto print surfaces to build 3D printed parts.

Also known as build sheets, stick these sheets to your printer bed for more accurate 3D printed parts than those made on bare printer beds, masking tape, and glue.

Shield your 3D printer's heating element, or hot end, from sticky filament buildup with these nonstick silicone covers. By repelling plastic and keeping the heating block clean, they increase the heating block's life and prevent stuck filament from dripping off and ruining prints.

Create circuit prototypes and other conductive pathways with these low-maintenance PLA filaments.

Bumps, scrapes, and falls won’t damage these tough filaments. Known for their durability, they absorb impact without cracking or breaking, and won’t degrade when heated. Use them to print tool handles, storage cases, and other parts that are handled or dropped frequently.

Absorbing blows and resisting fire, these ABS filaments produce holders, guards, housings, and other parts that protect sensitive, flammable equipment and machinery.

Create gears, bearings, washers and other hard-working parts that may be used in or near flammable machinery.

Stretchy, soft, and sturdy, these filaments make durable parts that resist wear and breakage despite repeated use. Stronger than ABS and PLA filaments, they create long-lasting, wear-resistant parts, such as seals, sleeves, and gaskets, as well as components that take on high-impact forces, such as springs and snap-fit parts.

Made of pliable TPU with a conductive compound, these filaments produce wire, circuits, and other components that direct the flow of electricity in wearable and flexible devices, from watches to grippers.

Fabricate custom bottles, packaging, and other parts for chemical processing.

Not only do parts printed from these filaments protect sensitive electronics, but they also hold their shape in temperatures that would deform or degrade most plastic. Use them to make parts for hot environments, such as engines, ovens, or lighting equipment.

Parts printed with these filaments absorb less moisture than other types of plastic, making them ideal for use in wet or humid environments.

Compatible with the MakerBot Replicator 2 Desktop 3D Printer and all Fifth Generation MakerBot Replicator 3D printers.

With the male threaded end on these inserts, mount components directly to plastic parts.

The tapered shape makes it easier to guide these inserts into a hole during installation. Use a drill bit to create a straight hole, then taper the top half.

These aluminum inserts are lightweight, nonmagnetic, and mildly corrosion resistant.

Spray these primers onto a mounting surface to quickly and smoothly apply signs, labels, and protective films.

With a built-in controller and driver, these stepper motors come ready to program and operate.

A lead screw that converts rotational motion to linear motion sits inside the motor body for a compact footprint. Add a driver and controller to these actuators to repeatedly position loads with speed and precision.

These desiccants are best when relative humidity is at least 40%.

Place these dehumidifiers in small spaces to protect moisture-sensitive materials such as photo lenses or 3D printing filaments. While they don’t need a battery or power cord during use, you do plug them in to dry them out—unlike other desiccants, they don’t require an oven.

Move belts forward and backward or stop and start them in precise positions, especially in areas where rust is a concern.

Also known as thermal paste, these boron-nitride compounds increase heat transfer between parts while preventing them from sticking. Unlike antiseize compounds, they don't conduct electricity, so you won't risk shorting out sensitive electronics.

These petroleum-based, ammonia-free solutions are the strongest we offer.

Also known as aqueous cleaning solutions, these water-based solutions are for general purpose cleaning.

Often used for circuit-breaker housings, manifolds, and semiconductor components, Ultem PEI offers excellent electrical-insulating properties.

These pellets resist swelling when exposed to water, making them suitable for use in wet environments. Melt and mold them into desired shapes.

Add color when making plastic parts.