Made of stainless steel and rubber, these mounts resist corrosion from water and most chemicals. Natural rubber is resistant to tears and abrasion and has good flexibility in cold temperatures. Use mounts to minimize vibration between surfaces inside machinery and equipment, such as in circuit boards, small fans, compressors, and pumps. They're for use in compression and shear load applications.

For technical drawings and 3-D models, click on a part number.

Made of stainless steel and rubber, these mounts resist corrosion from water and most chemicals. Natural rubber is resistant to tears and abrasion and has good flexibility in cold temperatures. Use mounts to minimize vibration between surfaces inside machinery and equipment, such as in circuit boards, small fans, compressors, and pumps. They're for use in compression and shear load applications.

For technical drawings and 3-D models, click on a part number.

Made of stainless steel and rubber, these mounts resist corrosion from water and most chemicals. Natural rubber is resistant to tears and abrasion and has good flexibility in cold temperatures. Use mounts to minimize vibration between surfaces inside machinery and equipment, such as in circuit boards, small fans, compressors, and pumps. They're for use in compression and shear load applications.

For technical drawings and 3-D models, click on a part number.

Select these bumpers for applications that require specific load capacities. All are reinforced with a base plate for strength. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines and conveyors. Twist these bumpers into a threaded hole.

Bumpers with a medium hardness rating offer a balance of cushioning and impact resistance.

Bumpers with a hard hardness rating withstand more impact than softer bumpers.

Rubber bumpers are abrasion resistant. Those with a soft rating can be used outdoors.

Stainless steel studs are more corrosion resistant than steel studs.

For technical drawings and 3-D models, click on a part number.

Select these bumpers for applications that require specific load capacities. All are reinforced with a base plate for strength. Often used as feet, spacers, and vibration dampers, they absorb shock to prevent damage to equipment and surfaces. They're also good for starting and stopping motion on automated machines and conveyors. Mount these bumpers on a threaded stud.

Bumpers with a soft and extra-soft rating offer cushioning. The softer the bumper, the more it cushions. Bumpers with a medium and medium-soft rating offer a balance of cushioning and impact resistance. Bumpers with a hard rating withstand high levels of impact.

Rubber bumpers are abrasion resistant.

Polyurethane bumpers have better abrasion resistance than rubber bumpers. They won't become brittle and crack when exposed to ozone.

For technical drawings and 3-D models, click on a part number.

These clamps wedge against the workpiece ID to grip cast, unfinished, or uneven parts, leaving the outside clear for machining. Do not use these clamps on smooth or finished ID’s because they will leave a mark. The clamp’s screw tightens from the top of the clamp, so workpieces require a through hole. Thread the clamp into a tapped hole in your fixture and place your workpiece over it. Reach through the hole to turn the screw, expanding the clamp.

For technical drawings and 3-D models, click on a part number.

Hold a workpiece securely from the side with minimal contact, leaving more of the workpiece free for machining. Thread the clamp into a tapped hole and give the center screw a half turn for quick clamping.

For technical drawings and 3-D models, click on a part number.

Install these clamps into a slot in your fixture to grip at the bottom of workpiece edges, giving the cutting tool maximum access to your workpiece. Thread the clamp into a tapped hole and give the center screw a half turn for quick clamping.

Blunt edge is less likely to mar your workpiece.

For technical drawings and 3-D models, click on a part number.