Filter by
PEM® Part Number
System of Measurement
Thread Size
Hole Diameter
Material
Thread Length
For Material Thickness
Finish
Base Diameter
Connection Method
DFARS Specialty Metals
Drill Bit Decimal Size Equivalent
Export Control Classification Number (ECCN)
For Minimum Length Between Hole Center and Sheet Edge
Hardness
REACH
RoHS
Tensile Strength
Thread Direction
Thread Spacing
Thread Type
Threading
Press-Fit Studs
 |
Press these studs into a drilled or punched hole with an arbor press or similar pressure tool. Also known as self-clinching studs, ribs under the head hold the stud firmly in place. Length listed is overall length.
Zinc-Plated Steel—The most common choice for areas with occasional exposure to moisture.
Lg. | PEM® Part No. | Thread Lg. | For Min. Material Thk. | For Min. Lg. Between Hole Ctr. and Sheet Edge | For Hole Dia. | Hole Size Tolerance | Drill Bit Size, mm | Base Dia. | Tensile Strength | Hardness | Pkg. Qty. | Pkg. | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Zinc-Plated Steel | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
6-32 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 5/16" | FH-632-5 | 7/32" | 0.040" | 1/4" | 0.137" | 0.000" to 0.003" | 3.5 | 0.221" | Not Rated | Not Rated | 100 | 000000000 | 00000 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Pack of 100Delivers tomorrow 7-9 am  | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
