Filter by
PEM® Part Number
System of Measurement
Thread Size
Material
Hole Diameter
Finish
Connection Method
Thread Length
Drill Bit Decimal Size Equivalent
Threading
DFARS Specialty Metals
Export Control Classification Number (ECCN)
Hardness
REACH
RoHS
Tensile Strength
Base Diameter
For Minimum Length Between Hole Center and Sheet Edge
Thread Direction
For Material Thickness
Thread Type
Thread Spacing
Press-Fit Studs
 |
Press these studs into a drilled or punched hole with an arbor press or similar pressure tool. Also known as self-clinching studs, ribs under the head hold the stud firmly in place. Length listed is overall length.
Zinc-Plated Steel—The most common choice for areas with occasional exposure to moisture.
Lg. | PEM® Part No. | Thread Lg. | For Min. Material Thk. | For Min. Lg. Between Hole Ctr. and Sheet Edge | For Hole Dia. | Hole Size Tolerance | Drill Bit Size, mm | Base Dia. | Tensile Strength | Hardness | Pkg. Qty. | Pkg. | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Zinc-Plated Steel | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
6-32 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 3/8" | FH-632-6 | 9/32" | 0.040" | 1/4" | 0.137" | 0.000" to 0.003" | 3.5 | 0.221" | Not Rated | Not Rated | 100 | 000000000 | 00000 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Pack of 100Delivers tomorrow 7-9 am  | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
