These sealants include a material certificate with traceable lot number, test report, and product shelf life.

These sealants include a material certificate with traceable lot number, test report, and product shelf life.

Also known as neutral-cure sealants, these won't discolor copper, brass, and concrete.

Tested to meet ASTM E595, a standard used by NASA, these sealants fill joints and seams while releasing almost no volatile emissions that could damage sensitive electronics, even in a vacuum.

A combination of hardness and surface tension makes these sealants resistant to punctures, cuts, and abrasion.

Meeting requirements for semiconductor, biomedical, and electronics clean rooms, these sealants won’t contaminate air and surfaces.

These structural sealants combine the mechanical strength of an adhesive with excellent sealing properties and high flexibility.

Made from silicone, these sealants are RTV (room-temperature vulcanizing). They combine the mechanical strength of an adhesive with excellent sealing properties and high flexibility.

Also known as thumb-grade caulk, this forms a non-hardening, moisture-resistant seal that remains pliable.

These non-sagging sealants will not drip while hardening on vertical and overhead surfaces.

These sealants are marine grade, so they stand up to water, corrosion from salt spray, mildew, and UV light.

These non-sagging sealants will not drip while hardening on vertical and overhead surfaces.

Thinner than non-sag sealants, these flow easily into cracks and have a smooth finish.

Thinner than non-sagging sealants, these flow easily into cracks and have a smooth finish.

To allow time to adjust and position parts, these epoxies remain workable for at least 90 minutes.

Assortments include eight different epoxies in 0.1-oz. packets to handle a variety of small jobs.

These machinable epoxies are mixed with steel, but won’t rust, so they can be used to repair cracks and threaded holes.

For invisible bond lines, these adhesives dry clear.

Fasten hard-to-bond plastics, such as polypropylene and polyethylene, with these epoxies.

These self-extinguishing epoxies meet UL 94 V-0 for flame retardance.

With high shear strength and peel strength, these form the strongest bonds of our urethane adhesives.

Solvents, oils, acids, and other chemicals won't degrade the bond of these adhesives.

To keep these adhesives from squeezing out during clamping and give a consistent bond thickness, they're mixed with small glass beads.

Fasten hard-to-bond plastics, such as polypropylene and polyethylene, with these adhesives.

These thick gels fill gaps up to 0.2" wide—the largest of any of our instant-bond adhesives.

Use these thick gels, also known as super glue, on vertical surfaces or to fill gaps between parts.

To invisibly bond transparent plastics, these adhesives won’t turn cloudy.

For faster bonding, these adhesives begin to harden in half the time of our other wicking instant-bond adhesives.

Accommodate joint movement with these adhesives that remain pliable when cured.

In especially damp or humid environments, these adhesives keep their hold.

Form bonds without the strong odor of other instant-bond adhesives.

To invisibly bond transparent plastics, these adhesives won’t turn cloudy.

These thin liquids, also known as super glue, flow into small gaps.

Make strong, instant bonds on a variety of materials—but not your skin.

For easy positioning, these adhesives begin to harden only when exposed to light.

Moisture, humidity, and immersion in water won't degrade the bond of these adhesives.

Remaining flexible after curing, these glue sticks accommodate joint movement.

Bond glass and stone to drywall, treated lumber, and subfloors.

Bond and repair nosing and stair treads with this thick, two-part epoxy.

Form bonds with twice the strength of our other spray adhesives.