Clear All
    For Use On
    For Use On
    Show
    UHMW Plastic
    Container Type
    Container Type
    SyringeStick
    Maximum Temperature
    Maximum Temperature
    250° to 499° F
    500° to 999° F
    Reaches Full Strength
    Reaches Full Strength
    30 min.
    60 min.
    8 hrs.
    24 hrs.
    Manufacturer Model Name
    Manufacturer Model Name
    HighHeat
    Original
    Plastic Bonder
    PlasticWeld
    Type
    Type
    Adhesive
    Consistency
    Consistency
    Paste
    Thick Liquid
    Putty
    Manufacturer
    Manufacturer
    J-B Weld
    Formulation
    Formulation
    Epoxy
    Urethane
    Begins to Harden
    Begins to Harden
    5 min.
    15 min.
    20 min.
    60 min.
    4 hrs.
    Cure Type
    Cure Type
    Room Temperature
    Clarity
    Clarity
    Semi-Clear
    Opaque
    Mixing Required
    Mixing Required
    Yes
    No
    Adhesive Type
    Adhesive Type
    Structural
    Elongation
    Elongation
    1%
    2%
    100%
    Approximate Coverage
    Approximate Coverage
    10 ft. @ 1/8" dia. bead
    20 ft. @ 1/8" dia. bead
    Peel Strength
    Peel Strength
    Not Rated
    Mix Ratio
    Mix Ratio
    1:1
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    5 Products