Protect your fire alarm stations from damage.

In addition to an audible signal, these alarms flash a high-intensity strobe to draw attention during fire emergencies.

Link multiple detectors in tandem to warn occupants outside the vicinity about potential fire hazards; if one unit is activated, they're all activated.

When visible smoke particles or carbon monoxide is detected, this stand-alone detector alerts you with an audible alarm.

When the temperature climbs above the temperature rating, the detector sends a signal to your control panel.

Check that your HVAC smoke detector is working properly. Wire these test stations to your smoke detector controller to test difficult to access smoke detectors from a convenient location.

This spray smoke simulates fire conditions to make sure your detectors are working.

These make great doorbells when used with a push button.

When this horn runs out of air, recharge it with the included pump.

These horns have disposable canisters that can be replaced when the propellant is gone.

Buzzers are UL listed for use in environments where flammable gases and combustible dust may be present.

Horns are UL and C-UL Listed for indoor and outdoor use in Class I, Division 2, Groups A, B, C, and D, Class II, Division II, Groups F and G, and Class III hazardous locations.

The quick-opening valve on these whistles allows manual operation—pull the valve while air or steam pressure is being applied to produce a shrill tone and alert workers.

Just like the bells you hear at service stations, these bells ring when a vehicle drives over the attached hose.