These pins combine the locking capabilities of a clevis pin with the precision diameter of a dowel pin for a tight fit.

A large loop handle makes these pins easy to grip.

A plastic-coated T-handle welded to these pins makes them easy to grab.

Slide a retaining ring into the groove for a secure hold that takes up less space than a cotter pin.

Sized to fit snugly around pipe and tube, these pins use spring force to keep the retainer closed.

A swivel handle makes these pins easy to install and remove, while the toggle locks them in place. Flip the toggle to release the pin.

A spring holds these pins tight, while a toggle locks them in place. Flip the toggle to release the pin.

A 60° beveled head fits into a countersunk hole.

Push parts out of molds with these hardened pins. Also known as knockout and forged pins.

Pass these pins through a mounting hole and weld the head to the surface.

Use the key to unlock these pins, then press the button to release the spring-loaded retaining balls. Two-step locking prevents accidental removal.

Also known as double-acting pins, these pins lock in place until you push or pull the handle to release the spring-loaded retaining balls. The T-handle is easy to grip.

Four spring-loaded retaining balls provide extra holding power. Made entirely of stainless steel, these pins stand up to corrosive enviroments. They lock in place until you push the button to release the spring-loaded retaining balls.

These pins adjust to take up play in a system or hold parts in holes of varying thicknesses. Spin the handle up or down, then tighten the locknut to change the length by up to ½”. Pins lock in place until you push the button to release the spring-loaded retaining balls.

Two spring-loaded balls give these pins more holding power than quick-release pins with only one retaining ball. The balls pop out when the pin is pushed into a hole, and retract when the pin is pulled out.

Install by hand or with a hex key in low-clearance applications.

Lock the nose into the retracted position by pulling the knob and rotating it 90°.

Quickly align, join, or hold machine components in place in food, pharmaceutical, and other sanitary environments. Pulling the plunger knob and twisting it 90° will lock the nose into its retracted position.

Lock the nose into the retracted position by pulling the knob and rotating it 90°.

Retract the nose by pulling the knob.

Ensure horizontal alignment of pipe flanges with a level rod that runs between two alignment pins.

Each step on these aligner pins matches common bolt holes on pipe flanges, so they're more precise than conical aligner pins and don’t require nuts. Press the pair of pins into mated flanges to make sure the flanges are aligned.

Often called bull pins, these pins are designed to resist mushrooming caused by repeated pounding.